At present, China’s independent innovative and developed food conveyor, under the background of increasingly mature international development, the market scale continues to expand, and gradually march overseas, began to spread to Southeast Asia, Africa, Latin America and other fields.

Driven by energy conservation and emission reduction policy and related constraint indicators, reduce dust, noise and waste of the conveyor, reduce energy consumption, develop energy conservation and emission reduction transmission technology, expand the scope of the conveyor, increase the conveyor capacity, expand the length and angle, and accelerate the development of large-scale conveyor equipment to meet the main direction of the conveyor market.

Food food conveyor network belt has gradually been widely used, its super high performance has been highly praised by the majority of users, but the network belt in the operation of some skid phenomenon, so what are the main reasons for these skid phenomenon, we will have a detailed understanding:

 1. The initial tension is too small. Insufficient tension of the food conveyor network belt leaving the drum causes the conveyor belt to slip. This generally occurs at startup, and the solution is to adjust the tension device and increase the initial tension.

 2. The rear roller bearing is not damaged or the upper and lower roller bearing is not damaged too much. The cause of the damage is too much tail ups and downs, not timely repair and replace the damaged or not flexible parts, so that the resistance increases by fighting

 3. Start speed too fast can also form a skid. You can start up very slow. If the use of rat cage electricity, can be clicked twice and then started, can also effectively overcome the skid phenomenon.

 4. Insufficient friction between the drive roller and the conveyor belt causes a skid. Most of the reason is water or wet environment on the conveyor belt. The solution is to add some final rosin to the roller. But we should pay attention not to use hand injection, and the application of blower equipment blowing in, so as not to avoid personal accidents.

 5. The load of the food conveyor network belt is too large, exceeding the electrical capacity will also slip. The beneficial side of the skid at this time is that electricity, otherwise electricity will be burned for a long time.

The main reasons for the skid phenomenon of the food conveyor network belt in the operation process are these. We must pay attention to these matters in the application process, and only by preventing them in advance can we improve our delivery efficiency. Food conveyor network belt has been widely used in the transportation industry, it has become a more common conveying equipment, in the major conveyor installation loose must pay attention to, we need to install tight, which can prevent skid or loose, if installed tight, too tight will lead to the pressure between food conveyor belt and machine equipment, wear increase, not conducive to daily maintenance and maintenance, and serious will lead to the network of food conveyor belt deformation, which may affect the quality of the products.

Also some users in the daily maintenance, in order to figure lazy trouble, directly adjust the network belt tight, convenient save trouble. However, no matter what situation leads to the tightening of the food conveyor belt will greatly reduce the service life of the food belt and machine equipment, and also affect the quality of the products to a certain extent.

Looseness should be noted when installing the food conveyor network belt